Brand: Monterey
UPC: 022179104433
Broad spectrum preventative biofungicide/bactericide for control or suppression of fungal and bacterial plant diseases. Spray on plants to control powdery mildews, leaf spots, anthracnose, gray mold and other diseases affecting plants. For use on vegetables, ornamental and fruit trees, shrubs, lawns, flowers, bedding plants and potted ornamental plants. As little as 1 teaspoon per gallon of water needed for one application.
- Active Ingredients: Bacillus Amyloliquefaciens Strain D747 98.85%
- Application Method: Sprinkle; Spray
- Use Instructions: MONTEREY COMPLETE DISEASE CONTROL BRAND must be mixed with water and applied as a spray to fruit and foliage, or as a drench to plant roots. See below for specific mix rate information. Application Rates and Methods: Spray application for control of powdery mildews, leaf spots anthracnose, gray mold, and other diseases affecting leaves, flowers, fruit, and other above-ground plant parts of home garden plants: Mix 1 teaspoon of MONTEREY COMPLETE DISEASECONTROL BRAND per gallon of water and apply directly to plants using a hand pump sprayer or other suitable spray equipment. Spray just enough to wet all leaves and fruit with minimal run-off or dripping. Total coverage depends on the size of plants to be sprayed and the type of sprayer used. Repeat as needed to maintain disease control, typically every 7-10 days. If disease is prevalent or environmental conditions such as high humidity favor disease outbreak, increase the mixing rate to 1 tablespoon per gallon and shorten the interval between sprays to every 3-7 days. Drench application for control of diseases affecting plant roots, tubers, or other parts of plants in contact with soil in the home garden: Mix 1 teaspoon of MONTEREY COMPLETE DISEASE CONTROL BRAND per gallon of water and apply to the soil by one of the following methods: For potted plants (indoors or outdoors), apply in sufficient water to wet the entire root mass using a watering can or tank-fed watering wand. Do not water plants again until 24 hours after application. Alternatively, use a hand-pump or other sprayer to spray the mixture on the soil surface in each pot, then immediately apply sufficient water to move the product into the roots. Drench the roots of transplants with approx. 4 fluid ounces of the mixture immediately before transplanting into pots or garden soil. Allow to soak into the root ball before transplanting. For outdoor-grown plants, use a watering can or sprayer to drench the soil in the planting furrow or transplant hole immediately before planting or transplanting. The amount of water required will depend on the size of the hole or length of furrow. Alternatively, apply in the first watering after planting or transplanting, either by mixing directly into the water at the rate indicated above, or by spraying onto the soil surface at the base of each plant and immediately watering in with a watering can, hose, sprinkler, or other watering device.
- Storage Instructions: Store in a cool and dry area.
- Caution: Keep out of the reach of children
- First Aid Measures: If in Eyes: Hold eyes open and rinse slowly and gently with water for 15-20 minutes. Remove contact lenses, if present, after the first 5 minutes, then continue rinsing eye. Call a poison control center or doctor for further treatment advice.If On Skin: Take off contaminated clothing. Rinse skin with plenty of water for 15-20 minutes. Call a poison control center or doctor for treatment advice.If Inhaled: Move person to fresh air. If person is not breathing, call 911 or an ambulance, then give artificial respiration, preferably by mouth-to-mouth, if possible. Call a poison control center or doctor for further treatment advice.
- Safety Warnings: It is a violation of Federal Law to use this product in a manner inconsistent with its labeling.